Ways to move a upright piano

Pianos consistently make movers annual list of products that are most frequently harmed. Grand pianos are particularly bothersome. Practicing the following treatments for dismantling, padding and packing grand pianos will prevent damage, lower claims cost, and enhance consumer satisfaction.

1) At least three people are required to deal with a child grand piano. If the child grand piano requires to increase or down stairs or if a complete or concert grand piano needs to be transferred, a minimum of 4 individuals are needed.

2) Always finish a accurate and thorough inventory. It may be required or more suitable to use a visual inventory to effectively explain and reveal pre-existing damage.

3) As different parts are taken apart, please place all hardware in a properly identified parts bag and after that position the parts bag in a "Components Box".

4) Eliminate the music rack (lyre) from its track by pulling it towards the keyboard. Wrap it in a tidy furniture pad.

5) Detach the cover by eliminating the hinge pins. Have someone wiggle the cover, holding it opposite the hinge, while a second individual works the pin loose. Please beware not to damage the wood with the pliers or with the pin itself. If required, cover the jaws of the pliers with a little cloth to assist prevent damage to the wood. Wrap the lid in a clean furnishings pad.

6) Remove the prop that holds the lid open and cover it in a tidy furnishings pad. The prop has a hinge pin and remains in 2 pieces.

7) Eliminate the pedal assembly and wrap it in a clean furniture pad. When eliminating the screws, please be mindful not to drop the braces. As you face the piano, number the push-rods from left to right as "1", "2", and "3", by placing a piece of masking tape with the appropriate number on each rod.

8) Pad the piano by putting a clean rolled furniture pad (stretch-wrap the pad to avoid it from unrolling) on the cover of the keyboard to prevent it from flopping open while you handle the piano. Note: Please make sure that see here the surface of the piano is dust-free before padding it.

9) Position a piano board and connect the straps so that it is prepared to receive the piano. The raised brace on the piano board should be at the keyboard end of the piano.

10) Remove the left front leg by positioning one person beneath the piano at the left end of the keyboard. Be sure to have 2 people lifting the corner of the piano while the 3rd individual gets rid of the leg. Keep in mind: Please be sure to keep in mind which legs were gotten rid of from which positions given that some pianos have legs that are not interchangeable.

11) Location the piano on the piano board by lowering the "leg-less" end onto the board. Please make certain to raise the whole piano a little while finishing this maneuver to prevent unnecessary pressure on the remaining, attached legs as the piano suggestions. Lift the piano to an upright position on the board. Note: Please ensure that the soundboard is safe and secure prior to lifting. Be sure that the piano is focused comfortably versus the brace at the end of the piano board. Keep in mind: Never ever leave the piano unattended. check this link right here now Always have at least a single person holding the piano consistent at all times.

12) Eliminate the two remaining legs and cover them in tidy furniture pads. These legs are held in location by a "key and slot" plan. To remove the leg, slide it inward towards the center of the piano until it comes out of the slot.

13) Secure the piano to the piano board by bringing completions of the straps together and fastening them. Location folded burlap pads over the furniture pads however under the straps to provide additional defense to the edges of the piano. To avoid the strap near the narrow end of the piano from slipping off, tie the loose ends of the 2 straps together.

14) To move the piano over a flat, level surface area, tilt the piano and piano board and location a four-wheel dolly under the center of the piano board.

15) To move the piano up or down stairs, use the piano board as a skid. After sufficiently padding the stairs for defense versus residence damage, put the keyboard end of the piano towards the bottom of the stairs. Connect a bulge strap to the leading end of the piano board to prevent the piano from slipping.

16) To pack the piano, leave it on the piano board and place it in a tier as the very first base item with the keyboard dealing with the wall of the preceding tier. The very best place to pack the cushioned cover is in between the piano and the preceding tier or in between the piano and the wall.

Although grand pianos represent a considerable obstacle, they can be moved without damage by utilizing typical sense and practicing the treatments noted above.

Leave a Reply

Your email address will not be published. Required fields are marked *